burst_dpsk_receiver
# Tune the receiver somewhat away from the SDR center frequency
# to avoid 1/f noise and DC
centerfreq 37500
samplerate 500000
-
none
# With no decoder selected, soft bits from the receiver
# are sent straight to ZeroMQ
-
zmq_output
address ipc:///tmp/dpsk-modem-rx
address_tick ipc:///tmp/dpsk-modem-rx-tick
-
psk_transmitter
centerfreq 37500
samplerate 500000
-
none
# With no encoder selected, bits from ZeroMQ go straight to transmitter
-
zmq_input
address ipc:///tmp/dpsk-modem-tx
address_tick ipc:///tmp/dpsk-modem-tx-tick
-
soapysdr_io
device:driver lime

# LimeSDR specific parameters
rx_stream:latency 0
tx_stream:latency 0

# If sample rate is changed, remember to change it
# also for receiver and transmitter
samplerate 500000

rx_centerfreq 434e6
tx_centerfreq 434e6
rx_antenna LNAL
tx_antenna BAND1
rx_gain 30
tx_gain 30

# Even with the performance-latency parameter set to 0 (low latency),
# LimeSDR seems to deliver samples in packets of 1024.
# Setting a smaller buffer size will cause samples to arrive
# in bursts of some 1024 samples.
# So, using a buffer smaller than that won't reduce RX latency much.
buffer 1024

# tx_latency should be at least 2 times, maybe about 4 times buffer size.
# Let's try 3 times it.
tx_latency 3072
-
