DL7OLG USB Reference Clock R1 — bare PCB fabrication

Board outline: 66.00 x 45.00 mm, rectangular, dimensions at Edge.Cuts centreline.
2 copper layers, FR4, finished thickness 1.6 mm, 1 oz copper each side.
Soldermask both sides (green); white top legend. ENIG finish preferred.
No impedance-controlled order option required. No panelisation supplied.
Smallest track 0.25 mm; clearance 0.20 mm; via 0.60 / 0.30 mm.
Separate Excellon files: PTH = plated; NPTH = non-plated M2.5 mounting holes.
Gerber profile is the outline; all files use the same absolute origin.
F.Paste is supplied for an optional top stencil. Bottom has no components.

Upload the Gerber ZIP for bare-board quotation. No order has been placed.
The two drill files must both be retained; do not merge plated and non-plated holes.
The drill maps are supplementary PDFs outside the Gerber ZIP.

Assembly: see ../BOM-Si598.csv, ../placement-top.csv and ../../docs/assembly-top.pdf.
BOM-Si570-alternate.csv is an alternative U3 assembly, not a second oscillator.
Exact oscillator order codes only; choose matching firmware profile.
Passive components are specified by value, tolerance, case and dielectric; an assembler
must confirm concrete manufacturer substitutions before PCBA. Headers are through-hole.
TP1..TP4 are copper test pads; H1..H4 are holes, neither is a purchased component.
Placement coordinates are KiCad native millimetres, front side, origin matching the board;
negative Y is intentional. Rotation must be mapped to the assembler's component library.
Pin 1 of U3 is marked by the small circle near the bottom-left oscillator land.

Digital design checks pass; the physical prototype has not yet been built or measured.
This package is not a claim of verified USB electrical conformity, RF phase noise or
frequency accuracy. Check output level and board connection before attaching the SXceiver.
