While reprogramming some radios we use at events, I decided to get my two Motorola DMR radios ready for amateur radio again: a DP4801 and an SL4000. I had already run into problems programming our commercial radios; the amateur-radio side was even worse.
The radios would not receive anything despite a correct codeplug. Why?
To put my experience briefly: the BrandMeister network did not work with older firmware. Anything below R2.10? Forget it! As with the commercial radios I had programmed, the problem involved OVCM and Talker Alias.
OVCM allows listening across groups. If the radio or repeater transmits the relevant bit, it is possible to hear a group that is not in the receive-group list.
Talker Alias, as the name suggests, transmits an alias. A preset name or identifier accompanies the ID, so the sender need not already be in the radio’s contact list.
OVCM works from firmware R02.10.10.0001 (R2.10), and Talker Alias from M2020.02. Both versions require CPS 2.0 for flashing.
Even if a repeater operator says OVCM has been disabled on the repeater or hotspot, that often only concerns local settings. Many operators seem not to have examined the topic closely. In the situation described here, BM master 2621 always transmitted OVCM from the network, causing Motorola radios in particular to fail decoding. Selecting master 2622 instead prevented the master from sending OVCM.
You might think the answer is simply to update the radios. That leads straight to the Motorola dilemma.
Older devices could still be flashed to R2.10 to support OVCM. Moving to M20xx.xx firmware for Talker Alias, which could also cause trouble, required purchasing Motorola’s SUM option introduced with R2.10.
Motorola generally refused that SUM licence for older radios because of their age. No licence meant no update. Many amateurs wanting to use these devices on BrandMeister were left with radios that did not work, or did not work properly.
I faced the same problem. Selling my two radios, still in almost-new condition, and buying replacements was not an option for me.
There is a way to bring these radios to their last possible software version. If you face the same problem, contact me; I can help.

